CLLS Marine Water Cooled Water Chilling Unit
CLLS Marine Water Cooled Water Chilling Unit
Overview
CLLS marine water chilling unit mainly consists of refrigeration compressor, marine high-efficient condenser,liquid supply solenoid valve, dry-type evaporator, electrical control cabinet, instrument and valves, etc.
All components of this unit are already assembled by the manufacturer; also pressure test and vacuum test for cooling system are already done. Sufficient amount of R404A gas is flled in,
Installation in Shipyard
1. Pay attention not to damage any component of the tube system and the unit during lifting. The body is made of thin steel plates, hangers shall be used for lifting. Wooden plate shall be used as protection pad for wall face in order to protect the body from damage.
2. See General Drawing or Overall Dimension Drawing for the dimension of bolt hole in the base of water chilling unit.
3. Shock insulation measures shall be considered at the base of water chilling unit.
4. Crelative valves and thermometer necessary for water inlet and outlet pipes of condenser shall be installed by shipyard,while water pressure gauge and water pressure controller have been properly installed by the manufacturer.
5. Connect feed cable conductor to the power line terminals in the electrical control cabinet, and lay the alarm wire, etc.
- Previous Product:CLN Marine Condensing Unit
- Next Product:CHLS Marine Water Chiller-piston Unit
